Write a Review
Our Products
We offer the best product range of Vibrating Table, Flow Table and Flow Table Motorised.
The Vibrating Table produces better concrete Moulds and cylinders by removing entrapped air. It distribute concrete evenly inside the moulds and nearly eliminate the problems of bug holes and air bubbles.
General Description and specifications :The Vibrating table is entirely constructed of thick steel. The table top is made of thick mild steel plate and has stops along its edges to prevent moulds from walking off the table during operation. A cross arm adjustable on a vertical rod at the centre of the table is provided to hold the moulds while operating the table. The variable pitch pulley arrangement permits the variation of frequency between maximum of 3600 vibrations down to 2600 vibrations per minute. A speed regulation handle is provided for increasing or decreasing the frequency. The vibrator is mounted on cushioned steel vibrating deck. A switch is provided for starting the motor. Operation on 440 V, three phase, A.C. supply.
Table Sizes
The consistency and workability of concrete is a very important factor and is strictly connected to the water/cement ratio, to the effect of admixtures and finally to the strength and quality of concrete. Suitable for concrete mixes of high and very high workability. To perform this test, a sample is placed on a metal surface which is then raised and dropped through a known height.
General Description And Specification: AS PER IS: 5512. FOR CEMENT MORTAR AND LIMEThe flow table consists of a brass table top 250 + 2.5mm dia mounted on a rigid stand. The table top is reinforced with equally disposed ribs and allowed to drop through 12mm by a ground and hardened cam, Complete with mould 100mm base dia, 70mm top dia and 50mm high. The cam shaft is rotated at the rate of 100 RPM by an electric motor. Suitable for operation on 230 Volts 50 cycles. Single Phase, A.C. Supply. Manually operated flow table also available.
As Per Is:199 For Concrete:The Flow Table consists of a brass or Mild steel table top of 76.2 cms(30")dia, finely machine from a solid brass casting or Mild steel Plate. The stand is fabricated out of cast iron/mild steel and is of study construction. The ground and hardened steel cam is designed to drop the table by 12.5mm. Complete with flow mould with handles with one tamping rod 0-60 cms long X 16cm. electrically operated to raise and drop the table top. approx. 15 times in 15 seconds. Suitable for operation on 230 volts, 50 cycles, A.C. Supply. Manually operated flow table also available.
Optional Accessories :
shaft is rotated at the rate of 100 RPM by an electric motor. Suitable for operation on 230 volts 50 cycles, single phase, AC Supply.
The flow table determining the flow of portland coment concrete. Consists of flow table a top 76.2 cms (30") dia, finely machined froma solid brass/gunmetal casting. The stand is fabricated out of cast iron/mild steel and is of study construction. The ground and hardened steel cam is designed to drop the table by 12.5 mm. complete with flow mould with handles with one tamping rod 0-60 cms long X 16 mm dia. Electrically operated to raise and drop the table top. Approx. 15 times in 15 seconds. Suitable for operation on 230 volts, 50 cycles, A.C. Supply.
Kunal Parikh (EIE Instruments Pvt. Ltd)
10th Floor, Span Trade Centre, Opp. Kochrab Ashram, Near Paldi bus stand, Paldi, Ahmedabad, Gujarat - 380006, India
Share us via
