Elab Engineering - Rolling Machine

LongitudalGrooves on Bottom rolls for correct Feeding of Plates. Build in Lubricated Storage. Circumferencialand Axial Grooves on Gun Metal Bearing for even Lubrication. Gun Metal Bush Bearings. Dropendopening system for easy removal of rolled shells. Minimisedfeeding height for easy operation. Well balanced design. Controlled roll speed for accurate curvature performance. Indicators provided for correct even top rollpresure. Mechanical device Mechanism for easy sliding of non drive side top rollhousing. Motor of reputed make. Worm Reduction Gear-Box of reputed make. Reverse Forward starter with overload thermal relay ofreputed make like Siemens/L & T/Cutler Hammer/HKS. One piece fabricated heavy duty base frame. UNIQUE SPECIAL DESIGNED OPTIONAL: Extended rolls (To be orderedalongwithmachine) Dies for rolling of angles, channels, pipes, flats, I-beam etc Attachment for conical rolling. Extra heavy base frame (for site work) Direct coupled gear box with electric motor and electromagneticbrake. Semi automaticcentralisedlubricationsystrm. Feedingplateform. Interchangeable extra top roll to roll shells of smallerdiameter Spilproofre-usable lubrication system. Manual or pneumatic or mechanical shell ejecting device. Remote floating control. Shell support device. Gun metal nuts for smoother manual rotation. 50% thick plates than the rated capacity canbe bent on the machine by hammering actionas shown while the thicker plates have to beprebentoutside the machine. Insert the plate between top roll and bottom roll by adjusting the top roll manually. Apply pressure on the plate by lowering the top roll, thenstart the main motor in forward direction till one end of plate comes over the first bottom roll. Then stop the main motor and reverse its direction so that other end ofthe plate will come on second bottom roll. Repeat the same procedure by applying thepressure from top roll till you get a perfect shell as shown on figure. For removal of rolled shell reduce the pressure of the top roll, make the shell free between top and bottom rolls, remove tilting end bearing of top roll manually and take out the shell, (Please note that top roll isbalancdby means of balancing screw.) Replace that bearing and the machine is ready for next operation.