Write a Review
Our Products
We offer a complete product range of Neutracoat Extreme
RUST-X VCINeutracoat Xtremeis a latex based primer, which can be applied with a brush or spray on the parts to be protected. The compound first converts the corrosion and then leaves a latex based layer on the surface which has a high salt spray life. The total action time is approx. 1-3 hours depending on the environmental conditions in which it is applied. It is highly active against corrosion conversion for the most damaged products that are hard to shot blast, sand blast or phosphate and works in extreme environmental conditions and provides long-term corrosion protection to the parts on which it is applied. The liquid is transparent or can be of any chosen colour upon application.
The VCINeutracoat Xtremeremains liquid even after years of application. This therefore does not cause any dimensional changes on the part. The VCINeutracoat Xtremeis compatible with Engine, Hydraulic and Transmission fluids and does not cause any detrimental effect on the same. VCINeutracoat Extremeconverts the metal surface layer in a chelating layer that converts the surface into hydrophobic passive layer. This is later than converted into a solid film due to the presence of water based latex polymers that works like a primer and prevents further corrosion. If very high salt spray life is required, then the layer can be plated or applied with thicker paints either water or solvent based.
Clean the area to be protected using a cloth or RUST-X 40 spray Apply the RUST-XNeutracoat Xtremewith a brush on the area to be protected Ensure that all the area gets covered evenly with the compound Check the reaction with the metal used before commercial application
Application and HandlingThis can be used to protect structures, chemical plants and equipments that are intended for outdoor storage or are located in open areas and need protection. These can also be used to protection unpacked refinery equipment oil pipleline equipment and valves, off shore refinery parts which are not painted or coated and require protection or during the storage while commissioning, for lay-up during shut downs and also on heat exchangers, wind mills and automotives. Due to a higher drop point the VCINeutracoat Xtremeit can be used on the chemical plant and equipment, which is in operation at elevated temperatures.
This can also be used to protect Defense Equipment and installations where extreme climatic conditions may have detrimental effect on the properties of the equipment e.g. on cannons, guns, artillery, launch vehicles etc. It can be applied on the machined surfaces of automotive equipment such as Transmissions, Gear Boxes, Engine Blocks, Flywheels, Hydraulic Pistons or other machined and unpainted surfaces to keep them from corrosion during storage and transportation.
Packaging Available25 ltr Can & 210 ltr Barrel
Safety InformationRUST-X oils donot contain Lead (Pb), Mercury (Hg), Cadmium (Cd), Hexavalent Chromium (Cr6), Polybrominated biphenyls (PBB), or Polybrominated di-phenylether complying with the re-stricted substances listed in Article 4(1) of the RoHS Directive. RUST-X Rust Preventive Oils are also REACH Compliant for exports to the European Union.
Sardar Jagjit Singh (Hi -Tech International)
St.1, Jammu Colony, Near Preet Palace, Ludhiana, Model Town, Punjab - 141003, India
Share us via
