Measurement Gauges & Fittings #6935853

A versatile tool, the Depth Gauge with Protractor allows for measurement of both angles and depths.

1. Manufactured from stainless steel, the protractor head has permanent deep etched graduations, 0-180 in opposite directions, thus permitting reading an angle directly and also its supplement
2. Depths are measured by a 6" (150 mm) steel rule. It is graduated in imperial dimensions on one side and metric on the other and can be set at any desired angle for use as a protractor and lengthwise when used as a depth gauge. A knurled thumbnut locks the rule in the desired position
3. The gauge has a flat surface on the back of the head permitting laying the tool flat upon the work. The rectangular head provides additional convenience as it incorporates 4 working edges
4. Angular Tolerance: 0.5
5. Head : Round & Rectangular

The ability to measure depths and angles is combined in this versatile tool.

1. The head is made from selected steel and has an attractive black finish. It is graduated both left and right to 15, 30, 45 and the rule can be set to any of these angles
2. A 6" (150 mm) steel rule is fitted to the head and can be locked in final position for depth or angular measurements by a knurled nut

A basis tool for machinists and toolmakers, the Universal Surface Gauge is used for accurately scribing lines, transferring measurements or probing surfaces in inspection work.

Design incorporates:
1. A fully hardened and ground base which serves as an accurate reference surface.
2. A machined Vee groove in the base allows the gauge to be used conveniently on curved surfaces.
3. A Vee groove at the front end allows the spindle to adjust to any angle above or below the base allowing it to be used as a height gauge and also as a depth gauge.
4. Two retractable pins allow the gauge to be located against the edge of a surface plate or T-slot for linear work.
5. Grooves on the side of the base allow for comfortable grip.
6. Well tapered scriber for better sighting while working. The scriber tip is hardened to 55-60 HRC.