Features : Double layers stainless steel to protect the material without pollution, easy to clean. Special drying method makes the hot wind pass to the material nicely, make it totally dry. The High-quality dryer could endure high temperature.
The moisture in the Plastic Resins (Hygroscopic and Non-Hygroscopic) will effect the surface finish and quality of the molded component. We have designed a compact and economical HOT AIR HOPPER DRYER to overcome this problem. Features Drying capacities ranges from 25 Kgs...
The system is used for heating of hygroscopic plastic granules and removing the surface moisture through them. It is mounted directly on the injection Moulding / Extruder machine. PID Temperature controller for accurate and precise temperature control. Uniform air...
Reliable : Air drawn in by the blower goes through the heater of a rectified flow and is spread evenly from the discharge port. Hence, the difference between the set and actual temperature is being minimized. MTIL's original diffuser cone prevents the short passing
Safe : The voltage tripping breaker (SHT type) trips upon overheating. A preventive device for external overheating comes together as an independent safety device from the temperature controller.
Environment Friendly : The long-lasting, easy to detach filter sheet keeps the molding environment clean.
Saves Energy : The dual structure of the heater box supports both heat exchange and thermal insulation. The dual structure of the lower hopper, whose temperature rises to the highest, prevents heat radiation.
Loaders are the simplest version of a ‘resin conveying system’ but they are not an integral part of a central conveying system. Self-contained vacuum loaders are used to transfer pellets, regrind and powders from a single source (usually a...
Features : High drying efficiency, Smooth pipe to avoid plastic dust, Internal parts are made of stainless steel, Electric temperature controller, Two overheat protection devices