Puncture test is a testing procedure that is used for evaluation of the strength of a material such as plastic films. The test is performed by performing compression on the material being tested. The compression is performed until the limited amount...
Gives Reliable indication to evaluate fabrication factors along with material values in a composite fashion. Direct indication on dial in Beach Units (oz.inchTech inch) Suitable to test as per IS - 4006 Part II - 1972 IS - 2771 Part II - 1973 TAPPI...
The geotextile specimen is clamped to obtain an inside dia of 44.45 mm and force is applied through an 8 mm dia plunger till failure. The puncture strength so obtained is felt to reflect the fabric’s ability to withstand aggregate penetration....
Fabric is clamped to give an inner diameter of 15 cm and a 50 mm CBR plunger is pushed centrally through a fabric at a specified rate. The load at failure is the push through load and when divided by the cross-sectional area of the plunger, gives...
The specimen is clamped on a fixture and is pierced with the help of a pendulum released from 90 degree position.the pendulum head is made pointed in a pyramid shape. Different weights are provided in the pendulum for different scales. A pointer is...
The specimen is clamped on a fixture and is pierced with the help of a pendulum released from 90 Degree position.The pendulum head is made pointed in a pyramid shape. Different weights are provided in the pendulum for different scales. A pointer is...
Puncture Resistance Tester is a consistent tool useful to determine the resistance to puncture of paper and paperboard. Puncture Resistance Tester is used to measure the resistance of paper, paperboard and other similar materials when subjected to...
The specimen is clamped on a fixture and is pierced with the help of a pendulum released from 90 Degree position.The pendulum head is made pointed in a pyramid shape. Different weights are provided in the pendulum for different scales. A pointer is...
Fabric is clamped to give an inner diameter of 15 cm and a 50 mm CBR plunger is pushed centrally through a fabric at a specified rate. The load at failure is the push through load and when divided by the cross-sectional area of the plunger, gives...
For Buyer 
For Seller 
Help 
