Delay timer in this dry run prevented suitable to all type of agriculture motors and starters (specially for 3 phase star delta & 1+3 star delta) features: suitable 12 hp to 50 hp motors it is used to give the delay signal it contains normally...
Application: The relay provides earth fault protection of Generators, Motors, Transformers, Feeder etc., and where definite time protection is required. Â Principle of Operation: The relay provides earth fault protection for power systems. Relay...
Features Software based design Wide auxiliary supply Low burden Principle of Operation: JRC 932 provides earth fault protection for power systems. Relay operating time is determined by the set definite time. The relay measures the current from the...
Our delay timer is available from 1 sec to 60 minutes timings in 10 steps with a choice of ON/OFF delay. The timer is suitable for continuous working in railway signaling and indoor use. Two change-over un-energized contacts with 5 Amps rating are...
The Delay Timer Module serves for the secure measurement of a preset time. The enabling signal for the control system, which for example makes it possible to open a guard device, is only given when the present time has elapsed. AZS range fail-safe...
SWA Order No. : SWA-1021-A1-R0 Â Technical Data: Â Â On delay and Off delay timer with preset value 0- 99 secs / minutes / Hrs Timer with relay output , 12V and 5V outputs...
Single-function and single-time relay with possibility of fine time setting by a potentiometer (within the frames of a particular time range). Suitable for applications where function and time requirements are known. Time switch, possible to be used...
MDDA Â Relay consists of a power supply unit, a timer unit and an attracted armature auxiliary relay. Resistor and Zener diode combination of the power supply unit provides low voltage stabilised DC supply to the static timer circuit. Non-linear...
NJS6 series time delay relay (hereinafter referred to as relay) is used as a time control element in control circuits with an AC voltage of 240V or below and a frequency of 50Hz and control circuits with a DC voltage of 240V or below to make and...
NJS2 Series Time Relay is applicable for controlling circuit @ A.C. 50Hz60Hz, up to 240V rated supply voltage and up to D.C. 240V rated supply voltage as delay element to make or break circuit according to preset time...
I n this Dry run prevented suitable to all type of agriculture motors and starters(specially for 3 phase star delta & 1+3 star delta) Features: . Suitable 12 hp to 50 hp motors, . Minimum and maximum current rating is changeable, . It is used to...
Code: EEB0007 Thyristor Time Delay Relay. Thyristor Time Delay Relay Power Electronic Training Board  has been designed specifically to study the operation of SCR and TRIAC triggered by electronic time delay circuit. This facilitates to perform...