Application : Supervision Of Gas Flames, Yellow Or Blue Oil Flames, Ignition Spark Proving
Supply Type : Manufacturer
Operation : Activated During Each Half Wave When UV Radiation Of The Flame Is High Enough
Specifications : Die-cast Aluminium Housing With 1 In. Mounting Coupling, Direct Mounting On Burner, Intermittent Use, IP54 Protection, Temperature Range: -20 To 60°C
* Sensitive Ultraviolet Sensor that detects the UV rays Produced by a flame * Aesthetically pleasing low profile design * Dust / Corrosion / Humidity Resistant * Standard Calibration Set to detect a 3 cm flame at 6 meters * Effective range up to 12...
Wide operating temperature range permits operation at higher ambient temperature 4-20 mA stepped output is the industry standard for remote alarm and fault indication Modbus and HART user interface provides complete status and control capability in...
The FlameGard 5 UV/IR E detects fires by monitoring in both the ultraviolet and infrared (UV & IR) spectral ranges making it highly immune to false alarms caused by lightning, arc welding, hot objects and other sources of radiation. The detector’s...
The precision-crafted FlameGard® 5 UV/IR Flame Detector monitors both ultraviolet and infrared (UV & IR) spectral ranges, which makes it highly immune to false alarms caused by lightning, arc welding, hot objects and other sources of radiation. The...
Siemens Landis manufacturer and supplier QRA series Photocell flame detector. These flame detectors have low sensitivity and are used for the supervision of gas or oil flames, yellow or blue burning oil flames and for ignition spark proving. The UV...
The HNL Flame Detector is a compact and highly responsive Flame / Fire Detector. The Unit incorporates an extremely sensitive sensing circuit that responds to high energy sources in a bandwidth of 185 – 260 nm with optimum spectral sensitivity...
A highly sensitive instrument to detect flames electric spark, tire in environments where catastrophic consequences could result from unwanted fire. It is particularly suitable for use in outdoor applications because it is not affected by wind or...
UV-IR Flame Detector is a combination of a UV andIR flame detector which utilizes a microprocessor for sophisticated electronic signal analysis. When a UV optical sensor is integrated with an IR sensor, a dual band detector is created that is...
With the simultaneous monitoring at four different wavelengths over the whole UV and visible range, the C-640 Detector allows you to detect and isolate your compounds using the Sepacore® Flash Chromatography systems. Detects most compounds in a...
Dual LED for 360 degree visibility – 02 wire based model – Easy installation and maintenance – High sensitivity and wide directivity – Sleek low-profile housing design – Quick detection of flame from Distance – SMD circuit board design-satisfactory quality and...
This test unit has been designed to generate a wide range of optical output signals. Flame sensors for fire detection and flame monitoring applications can be activated and tested. Most optical flame sensors respond to Ultra Violet (UV) and or...
These flame detectors give the highest immunity to false flame sources both indoors or out. They have internal self-test sources that check the detector’s operation when remotely instructed. The maximum ambient temperature is normally 55°C or...
U.V. Currency Detector is a boon for businessman, Bankers, Traders, Travel Agents, Post Offices, Railway and all other Institutions where a log of currency transactions take place. This units has one U.V. tube which helps in detecting all colour &...