Our Products
Features : |
-Bed is made from closed grain cast iron. Grade IS-20 Hardened & Ground. -Spindle is made form alloy steel & its Hardened & Ground. -Apron is fully oil bath. -Gear & Shaft of Norton gear box are made from alloy Steel & are toughened. -All wearing surfaces of rotating parts are made of gun metal. -Bed casting single piece upto 32'. -Spindle hollow available 52mm to 200mm. |
SPECIFICATIONS/MODEL | H | EH | XH | XXH |
Height of Centre | 255 | 305 | 380 | 450 |
Width of Bed | 325 | 380 | 455 | 555 |
Swing over Cross Slide | 290 | 400 | 490 | 600 |
Swing over Bed | 480 | 580 | 710 | 840 |
Swing in Gap | 785 | 885 | 1150 | 1300 |
Width of Gap in front | ||||
of Face Plate | 200 | 200 | 300 | 300 |
Spindle Hollow | 52 | 65 | 80 | 104 |
Spindle Speeds Nos./Range(rpm in G.P.) | ||||
Brass type | 8/30-550 | 8/30-550 | 8/30-550 | 8/30-550 |
Bearing type | 8/40-700 | 8/40-700 | 8/40-400 | 8/40-400 |
Type of Drive(Std.) | Flat belt | Flat Belt | Flat Belt | "V" Belet |
Optional | V-Belt | V-Belt | V-Belt | - |
Section | C | C | C | C |
Lead Screw | ||||
Dia/Thread(TPI) | 38.1/4 | 38/1.4 | 50/8.2 | 50/8.2 |
Full Norton: Number of Thread/Range | ||||
Metric | 17/0.5-15 | 17/0.5-15 | 19/1-30 | 19/1-30 |
Inch | 48/2-60 | 48/2-60 | 41/1-30 | 41/1-30 |
Auto Feeds: (in full Norton) | ||||
Longitudinal(mm/rev) | 0.065 to 2.0 | 0.065 to 2.0 | 0.078 to 2.340 | o.o78 to 2.340 |
Cross (mm/rev) | 0.015 to 0.048 | 0.015 to 0.048 | 0.015 to 0.048 | 0.015 to 0.048 |
Tailstock Ram Dia | 50.8 | 63.5 | 76.2 | 101.6 |
Morse Taper in Ram | MT-4 | MT-4 | MT-5 | MT-6 |
Ram Travel | 200 | 200 | 250 | 250 |
Electricals required | 3 HP | 3 HP | 5 HP | 5 HP |
RPM | 1440 | 1440 | 1440 | 1440 |
Tool Shank | 25 | 25 | 32 | 32 |