Kapasi Trading Corporation - Laboratory Apparatus

as per flash point (closed) by means of the ables flash point apparatus

ip23 and isi 1448 [part-i] 1960 [p:20]

it is designed as per i.p. 33 and i.s. 1448 ( part i) 1985. suitable for determining the close up flash point of petroleum and mixture according to ip 33 & ip 170 & also is 1448 (part 1) 1985 (p: 20). it is suitable for oils whose flashes are below 70c. it is supplied with oil cup, cover fitted with stirrer, water bath and stand. electrically heated with energy regulator control suitable to operate at 220 volt. 50 cycles, a.c. mains. supplied with ip thermometer.
1) with oil test jet

2) with gas test jet

optional :-

variable speed stirrer motor with flexible shaft mounted on mild steel rod with base.

digital temp. indicator unit having readability of 1c & maximum temp. of 400c with stainless steel pt -100 thermocouple.

copper coiled continuously variable temperature control unit.

CLEAVLAND Flash Point (Open) and Fire Point Apparatus.

(AS PER IP 34. ASTM D-93 AND IS 1209-1978 METHOD B).

Introduction:-

The apparatus is used for determination of flash point & fire point of petroleum products except fuel oil with open flash 80 C as per specification IP 36 / 57, IS 1448 (P: 69) 1969 and ASTM D 92- 67. Supplied with IP Thermometer.

The apparatus consists of a cup heating plate to specific dimensions thermometer clips and test flame attachments with swivel joint for passing over liquid surface in the prescribed manner, heater is controlled by means of energy regulator / suitable for operation on 220 volts 50 Cycles, A.C. Mains.

Available in Oil test Jet or gas Test Jet

Optional:-

Variable Speed Stirrer Motor with Flexible Shaft mounted on mild steel rod with Base.

Digital Temp. Indicator Unit having readability of 0.1C & maximum temp. of 200C with Stainless Steel PT -100 Thermocouple.

Copper coiled continuously Variable Temperature Control Unit.

Supply with  250ml beaker, teflon lid, tubular heater, RTD sensor, silicon oil (200g bottle), melting capaillary one end sealed (pack 100), boiling tube, teflon coated magnetic paddle, sample tapping rod, two melting standards 49deg c and 238 deg c power cord, operational & instruction manual with sop, calibration test centrificate( without tracebility document) and warranty card. 

TECHNICAL DETAILS:

• Temperature range:

15°C above room temperature - 300 °C.

• Accuracy: Better than 0.5 °C.

• Temperature resolution: 0.1 °C.

• Heating rate: 1 °C/minute or 0.5 °C/minute.

(Starts from set temperature – 10 °C).

• Power Supply: 230V, 50Hz, 500 W.

• Capillary: length -125 mm; Diameter: 1.4 – 1.6 mm.

• Display: 240 x 128 Graphic LCD.

• Input: Tactile Keyboard + PS - 2 keyboard.

• Compatible with DOT MATRIX printer.

PENSKY MARTEN FLASH POINT APPARATUS AS PER I.P.34, ASTMD 93 - 58 T and I.S. 1448 (part 1) 1970 (P- 21) 1203 1953).

INTRODUCTION:-
This method covers the determination of the flash point by pensky-martens of samples from

70C - 300C. Closed cup tester of fuel oils, lubricating oils, viscous materials, and suspension

of solids. This method is not applicable to drying oils, solvent-type liquid waxes, or utak asphalts.

SPECIFICATION:-

This Pensky Marten Flash Point Apparatus is made as per IP 34. ASTM D-93 and IS 1448 (PART 1) And IS 1209 -1978 method B. The apparatus consists of brass test cup with handle, removable cup cover with spring Operated rotating shutter having Oil Test Jet/Gas Test Jet Flame Device. Stirrer with flexible shaft. The assembly rests in air bath, which is covered, with dome shape metal top. The cup is fitted with insulated handle and locking arrangement near cup flange. The assembly is kept on round shaped Electric heater with Energy regulator temperature control. Suitable for operation on 220 Volts A.C. 50 Hz. It is supplied with I.P. Thermometer.

AVAILABLE IN OIL TEST OR GAS TEST JET.

OPTIONAL :-

Variable Speed Stirrer Motor with Flexible Shaft mounted on mild steel rod with Base.

Digital Temp. Indicator Unit having readability of 1C & maximum temp. of 400C with Stainless Steel PT -100 Thermocouple.

Copper coiled continuously Variable Temperature Control Unit.

1 DUSATube with 2 caps and Gaskets