Automatic Voltage Regulating Relay (AVR)

The AVR controller is a state of the art microcontroller technology based voltage regulating relay product form Proton. The AVR controller has the complete operating logic of the processes preprogrammed.

• Operating Modes:

The operating mode can be selected using TEST or NORMAL Mode front panel Switch: 

• NORMAL Mode:

> In this mode the AVR is operational. If PT input voltage is less than PT set point voltage minus hysteresis, then HIGH LED glow & there is a pulse of LOWER RELAY as per user setting pulse time & delay between two pulses & it clears if PT input voltage is greater than or equal to PT set point 
> If PT input voltage is greater than PT set point voltage plus hysteresis, then LOW LED glow & there is a pulse of RAISE RELAY as per user setting pulse time & delay between two pulses, & it clears if PT input voltage is less than or equal to PT set point . 
> If PT input voltage is less than UV set point then UV relay on & UV LED glow & it clears if PT input voltage is greater than or equal to UV set point plus hysteresis. 

• TEST Mode:

> In TEST mode there is one potentiometer at front side of unit, it is independent of PT supply. 
As per Potentiometer value voltage , Test Low & Test High LED glows as per PT voltage set point..

• Settings:

> To enter settings mode press set key and then press increment key for enter the correct password. 
> The password value can be set by using INC or DEC key & then press ENT key. 
> Press set key to move to next parameter. To edit parameter press increment/decrement keys 
> To save and exit SET mode press ENT key. 
> If no key is pressed then controller automatically goes to initial Display normal mode.
> The factory set password is 11.

• Latest micro controller based technology.
• Wide range of supply variation.
• 4 digit seven segment display.
• Voltage regulation control along with digital voltage readout.
• Trip delays for all protections.
• Message display for faults.
• 4 key interface for on site settings.
• All set points settable by keys.
• Set Parameters are password protected.
• LED indication for status of relay & voltage.
• MODBUS RTU protocol connectivity over RS-485 Electrical Standard
• GSM Communication to know working status of unit and fault if any.
• Customization needed if any.