SumiP FRP Poles, Standard : ASTM D 4923- 01

Sumip fiberglass light poles are constructed of Polyester/Epoxy resin systems & fiberglass woven rowing with more than 65% of the reinforcing fiberglass in the axial vertical plane which increases desired rigidity & axial strength. Sumip light poles and round tapered poles are available with two base options, direct Burial type & Anchor base type.   

• The surface will be free from crack or bubbles, damage, any exposed fiber & smooth surface shall be uniformly colored.
• The FRP pole will be finished uniform coating equal to the performance of the aliphatic polyurethane.
• Standards followed :
  a. AASHTOLTS-4 : standard specification for structural support for highway sings, luminaries & traffic Signals.
  b. ANSI C 136. 20-1990: Fiberglass Reinforced Plastic Lighting Pole.
  C. IS 875 (part 3) 1987: Code of practice for design Loads for building & structures WIND LOAD.
• The pole length lave a tolerance of not exceeding 0.3m. Per 10m.
• Deflection of the pole as per the AASHTO LTS- 4 shall not exceed a 15%(Depends upon requirement of the length of the pole above the ground line. When subject to maximum wind loading & shall not have more than 1% permanent deflection.

The poles are available with two types of Bases:

1. Anchor type- This type is installed on ground using base plate and fittings
2. Burial type- This type is installed on ground burying little bottom portion of the Pole with anti- rotating rods for proper fixing.

Both type of poles are available with different mounting type:

• Top Mount type
• Side Mount type
• Arm Mount type

Junction Box/ Hand hole is available.