Even in the cleanest and best designed clean steam systems, moisture entrainment is possible. This might result in unacceptably low dryness fraction, non-compliance of critical sterilization standards, damage to control valvesinstrumentation and...
Condensate pipe carries approximately 90% (by volume) of flash steam, and 10% of condensate. This bi-phase condition occurs immediate downstream of the trap or discharge orifice. To recover the flash steam, the bi-phase fluid has to be separated...
Condensate when discharged from higher pressure to lower pressure, the difference in the sensible heats at the two pressures causes certain amount of Condensate to again convert to Steam known and referred to as Flash Steam. This is as good as dry steam, albeit at lower...
We are counted among the foremost Manufacturers and Exporters of an exhaustive array of Steam Separators that finds extensive usage in boilers for the purpose of separating a mixture of vapor from liquid phases of water. Moreover, our Boiler Steam...
The steam is used in the process plants at various pressures depending upon the temperature requirements. The condensate from the high pressure steam when comes to low pressure, some part of the condensate get evaporated which is called as flash...
Formation of flash steam Flash steam is produced when high pressure condensate is discharged to a lower pressure. The word ‘flash’ describes the way it is formed. At atmospheric pressure, water boils at 100 Deg. C. Inside steam piping or any...
Forbes Marshall moisture separators effectively remove the moisture from steam ensuring the highest dryness fraction at the outlet. These moisture separators are available with IBR test certifications if required. Forbes Marshall offers a wide range...
For Buyer 
For Seller 
Help 
