Write a Review
Our Products
We offer a complete product range of Curing Compound Mould and Mortar Mixer
The mould is as per ASTM-C-156-1980. The mould is made of stainless steel and it is water tight. The mould is rigidly constructed to prevent distoration and it is thoroughly clean. The interior faces of the mould is plane surface. The mould is 150mm X 300mm at the top, 143 x 295 mm at bottom, and 50 mm depth measured on the inside. The mould is flat rim at the top on all sides approximately 6mm in width. A wooden float has a dimension of 75 mm X 280 mm X 20 mm thick is also be provided. The packing rod to be supplied with mould is made of non-absorptant, non-abrasive, non-brittle rubber compound material. The packing rod is 150mm long and have cross sectional dimensions of 25mm X 12 mm with tamping face the form of a blunt torpedo. S.S. Mould 300 x 150 x 50 mm.
It is used for mixing cement pastes, mortars and pozzolanas. The mixer consists of an epicyclic type stainless steel paddle imparting both planetary and revolving motion. Mixer have two speeds. Mixer blade has low speed of 140 + 5 rpm and medium speed of 285 + 10 rpm, while it also has a planetary movement of 62 + 5 rpm in low range and planetary movement of 125 + 10 rpm in medium range. Stainless steel bowl fitted with handle, fitted with lid made of non-absorbing material and not attacked by cement, masonry cement, cement pozzolana mixture or lime pozzolana mixture. The scraper consists of semi rigid rubber blade attached to a handle about 150 mm long. The blade about 75 mm long, 50 mm wide and tapered to a thin edge. Suitable for operation on 230 Volts, single phase.
RELEVANT STANDARD : IS : 4031, IS : 1727
EIE Instruments Private Limited (EIE Instruments Private Limited)
A-1301, BVR Ek Opp. Hotel Inder Residency, Near Gujarat College, Ellis Bridge, Ahmedabad - 380006, Dist. Ahmedabad, Gujarat, Paldi
Share us via
