INSTRUCTIONS AND METHODS OF USAGE DIRECT DETECTION Press the direct key and use the probe to touch the test circuit e.g. the phase line, Display screen will show the voltage value and the last value showing on screen is the measured voltage. If there is no current is passing...
Precautions : Voltage on test terminals. High Voltage on test jig appears only after the variac is set to zero and gradually increased. There is a trip device to trip if the current increases than the required value
: Protection provided with zero start to prevent accident availability of High
Trip settings : The tripping can be reset by a pot which can be varied as peruse requirement
Power Requirements : 230 volts AC, ± 10%, 50/60 Hz
Accuracy Of Reading : ±2%
Open Circuit Voltage : 0to5KVOR0to 10 KVAC. The above voltage can be continuously varied from zero to full value and is continuously monitored by Analog/Digital Panel meter.