<5% : 1) Frequency : 0.1Hz, 0.05Hz, 0.02Hz
2) Timing: 0-99 minutes.
3) Test Voltage: Zero to rated kV.
4) Trip Current: Zero to rated mA.
0.1Hz, 0.05Hz, 0.02Hz. : Fluctuation < 0.5%
1) Self-check. if condition is abnormal, tester
shuts down & displays ‘Load unconnected’
2) Mains fuse.
3) Over voltage protection.
4) Over current protection.
5) Protective HV resistor connected inside. : In two units: Controller and Booster..
One knob manual control, continuously variable through torodial auto transformer. : 2-20-100 mA.
Settable : Thumbwheel switch:1-99 seconds Display: LED Digital 2 digits, countdown. Resolution: 1 second Accuracy: ± 5% : HV switched ON by remote switch. Timer does not funciton in this mode.
For high voltage testing, using hi-pot testers is quite a common practice. Working with high voltage is not an easy thing. First important thing is maintaining safety and a second important thing is analyzing data carefully. For this reason, you...
Description :- These are electrical safety test devices that are commonly used for performing electrical compliance tests. There are different types of measurement performed by hipot testers including AC dielectric strength, DC dielectric strength,...
For Buyer 
For Seller 
Help 
