Drosophila Test Chamber

(Experiment Protection) Adjustable high and low temp. controls, audible alarms, and visual in directors are provided.
the controls shut down all the power to the chamber, and activates alarms. when the temperature returns to the normal range the system will auto-matically reset.

Three tiers of lighted shelving is lit by LED fluorescent white lights & tungsten incandescent lamps properly spaced for
uniform light intensity. Intensity is adjustable from 600 to 2000 μmoles/m2/s at 150mm distance from the lamps. Programming and control of the lighting is done controller between temperature +100C to +400C. Lamps with 3 on/off light events.Par sensor for light measurements.

Three tiers of lighted shelving is lit by LED fluorescent white lights & tungsten incandescent lamps properly spaced for
uniform light intensity. Intensity is adjustable from 600 to 2000 μmoles/m2/s at 150mm distance from the lamps. Programming and control of the lighting is done controller between temperature +100C to +400C. Lamps with 3 on/off light events.Par sensor for light measurements.

+100C to +600C with lights ON

+00C to +600C with lights OFF

Uniform forced air circulate across the shelf via air diffusers on the top wall.

0-2000 ppm complete with cylinders & regulators operated directly from PLC with NDIR sensors.

Built-in temp. deviation,audio/visual alarms. Safety thermostat for over shooting of temp. safety circuit to cut of the whole
systems in case of malfunction. (only applicable to microprocessor based models). HRS fuses for compressor heaters & mains.

Air cooled condensing unit which is self contained with hot gas bypass system for continues compressor operation.
Temperature control in accurate and it extends its life by alternately cycling refrigerant and hot gas to the coil. Long
solenoid values for quiet and long life operation.

PLC based PID controller with5.6” LCD is capable of controlling temperature, humidity, CO2
and lighting. Programs may be configured to run in real time or countdown (circadian) mode. Ramping and nonramping program methods are available for each programming mode. Multiple programs are linked to create complex environmental profiles. additional information
regarding the control system 25 steps PLC with HMI based temp. & RH controller, with 50 real time use entered
programs in with 99 cycles in each programs. provides precise temp.,RH, Humidity, illumination & CO2 maintaining uniform & accurate growth environment. Timer, alarm, auto tuning & auto start, stop function. with printer interface
(centronic port). PC interface with RS232CPS / RS-485 interface for multiple networking of controller. Data loggers up profile controller for Ramp / soak for cyclic application chamber illumination of U.V. Lamps. Low water level circuit etc. Also available stand by humidity & refrigeration system (Manual & auto change over) as optional. Auto diagnostic feature. Ambient temp. monitoring. Autorestart in case of power failure. 24 hour chamber monitoring 4 level password protection for controller operation.

Interior Made of 22 guage plated steel exterior of 18 guage plated steel construction 51mm thick puff panels with puff in place dencity
of minimum 1 kg per cubic foot or its equivalent. Insulation with expanded polystyrene or any equivalent. material having R factor of minimum 34 shall maintain its dimensional stability in an operating temperature range of +40C to +500C.
Insulation panel or its equivalent shall have cam-type fasteners with vinyl gasket or its equivalent. Environment friendly foam (Global warming potential of 0.0 & ozone depletion potential of 0.0 )

Two reach in doors for full access. Doors shall have magnetic snap-in perimeter gasket or its equivalent, self closing cam lift
gravity hinges or its equivalent a posi-seal door closure or its equivalent. Door shall have key lockable latch handle with an inside safety release. Magnetic gasket is provided for a tight seal.