Duraflex Waterproof Coatings

We offer Duraflex Waterproof Coatings that are aesthetic, as well as water and weatherproof, durable coatings. The Duraflex Waterproof Coatings are far better than plastic emulsion paints, which are in use for aesthetic look on interior as well as on exterior. Duraflex Waterproof Coatings that we deal in are protective, dust repellent and resistant to growth of microorganisms. Duraflex Waterproof Coating is a single component emulsion coating based on specially formulated emulsion polymer, inert fillers, UV durable lightfast color pigments and many other additives.

Benefits

• Single component, suitable for application by brush or roller
• Adheres strongly to a wide varieties of sound substrates such as cementitious, wooden, metals & tones etc
• Breathable, allows water vapor transmission hence decreases maintenance cost.
• Dust repellent, no adherence of dust to the coating and it can be easily cleaned.
• Resilient- it is so flexible with recovery properties so that it bridges the cracks due to changes in environment
• Water seal increases longevity.
• Ultraviolet resistance maintains aesthetic appearance.
• Prevents growth of algae, fungus and moss.
• Repels airborne pollutants and dirt that makes the substrate look new for years after application.
• Non-toxic, safe for the environment and the people applying it.
• Attractive color shades available, if required
• Coverage depends on the roughness and porosity of the surface

End Uses : Building facades from interior and exterior, sloppy roofs, manglory tiles, stone cladding, asbestos sheets, mosaic tiles, and wooden substrates. Direction For UseSurface Preparation Surface preparation is very important to get the best results and avoid failure. The surface must be sound enough, clean, free of dirt, oil, grease, sludge, moss, blistered cement coating, loose plaster etc. Thoroughly wire brushes the surface to remove saturated dirt and loose particles. Wash the substrate to remove dust. Sealer / Primer Coat The concrete or cementitious substrates are highly porous. It is necessary to make the substrate less absorptive so that the top coats film thickness remains same. Krishna SEALER is highly elastomeric acrylic emulsion polymer without filled system has extraordinary penetrating power which seals the porosity. Microcrevices of the substrate. It provides strong adhesion to the substrate and top coating. Due to non-filled system it overcomes the problem of linear stress and strain created in the substrate. Apply one coat of SEALER as a primer coat by brush. Apply the topcoat after one hour but within four hours of drying Application Mix the paint in the individual original container thoroughly to a uniform shade and consistency. Then dilute the required quantity with recommended dilutation ratio with water, to a homogenous solution. Consume the entire diluted paint at one stroke. Allow the coating to dry for at least 5 to 6 hours before applying successive coats. Cleaning : Tools and equipment to be easily cleaned with water immediately after use. Storage & Shelf Life : Store the material in a cool and dry place. Packing : 1,4, 20.Lts. packs. Precaution

• Do not apply in rain.
• Do not over dilute with water.