Fluid Bed Multi Technology FBMT

Fluid Bed Multi Technology FBMT Special Features

• 2 bar sock resistance construction.
• All contact parts made out of SS316.
• All motor are of flameproof.
• Inside of the all contact parts will be @ mirror finish and outside of all contact parts @ matt finish.
• Rh trans-meter at AHU.
• Inlet, outlet & product bed temperature sensors.
• Differential pressure trans-meter for Filter bag & differential pressure gauge for Hepa filter at AHU.
• A.C. Frequency drive for all motors.
• Sampling port at product container.
• Quick opening system for container sieve.
• CIP port and nozzles.
• Material charging ports , suitable for gravity and vacuum.
• PLC based power panel with touch screen based operating panel for automated process controls.
• Wash water drain port with valve at inlet plenum.
• All rubber gaskets of silicon.
• All light and sight glass with T/C clamp facility. 
• Pneumatic inflatable gaskets at bottom and top of the product container,  top of the expansion chamber and for air discharge bag sealing.
• CGMP construction.

• Dew Point Sensor at inlet air duct, instead of Rh sensor at AHU. 
• Velocity Trans-meter for CFM measurement.
• Differential Trans-meter instead differential pressure gauge at AHU and
• Differential Pressure Trans - Meter for container sieve. 
• Jacketed Vessel instead of non jacketed. (for Solution Preparation.).
• Flameproof Motor & Flameproof enclosure for panel for Solution Preparation Vessel. 
• Wet Scrubber at exhaust air. 
• Steam & Chilled Water Controlling Valve. 
• Peristaltic Pump of Master Flex-USA make instead of Indian make. 
• Flow Meter at Solution Spray System. [ Emersion make ( USA ) – Coriolis Type.]
• Flameproof/Weatherproof Enclosure for Touch Screen.
• Additional Duct per 1 Meter – Non insulated / Insulated. 
• Solid flow monitoring system.
• Reduce capacity bowl for top spray & bottom spray.