The Pneumatic vertical shock and bump test system features an advanced design with a high degree of performance and automation.The tester is easy to use and has low maintainence requirements.This equipment is used for conventional half-sine wave,post –peak sawtooth wave,square wave,impact response spectrum function and other shock tests.

• The system utilizes a pneumatic drive which features a simple structure,high reliability and enviromentally friendly operation.
• Greatly improves continuous shock test efficiency with a maximum shock frequency of 100 times/min.
• Large pulse width and small overload test are easily achieved.
• Higher reliability and better waveform compared with electric or hydraulic driven collision tables.
• Shock velocity can be controlled by adjusting the air pressure.
• The shock DAQ series control and measurement system can be Utilized and incorporated into the system for manual shock,continous shock,single shock,interval shock and other test types.
• The Self-Buffering base is designed to greatly reduce transmission of the shock force into the ground and allows the system to be placed directly on the floor of any standard mechanical industrial plant

The Pneumatic vertical shock and bump test system features an advanced design with a high degree of performance and automation.The tester is easy to use and has low maintainence requirements.This equipment is used for conventional half-sine wave,post –peak sawtooth wave,square wave,impact response spectrum function and other shock tests.

• The system utilizes a pneumatic drive which features a simple structure,high reliability and enviromentally friendly operation.
• Greatly improves continuous shock test efficiency with a maximum shock frequency of 100 times/min.
• Large pulse width and small overload test are easily achieved.
• Higher reliability and better waveform compared with electric or hydraulic driven collision tables.
• Shock velocity can be controlled by adjusting the air pressure.
• The shock DAQ series control and measurement system can be Utilized and incorporated into the system for manual shock,continous shock,single shock,interval shock and other test types.
• The Self-Buffering base is designed to greatly reduce transmission of the shock force into the ground and allows the system to be placed directly on the floor of any standard mechanical industrial plant