ASEW-219 Ductility Testing Machine: IS :1208 ASTM D113, AASHTO T51 Mould-3 Nos. Made of brass/gunmetal mounted on a base plate. Each mould has two end clips, two sides with knurled screws and side....
ASEW-219 Ductility Testing Machine: IS :1208 ASTM D113, AASHTO T51
Mould-3 Nos. Made of brass/gunmetal mounted on a base plate. Each mould has two end clips, two sides with knurled screws and side support for proper assembly on the base plate. One spare mould with base plate for casting the specimen is also supplied.
Water Bath Thermostatically Controlled : A bath maintained with ± 0.1 °C of the specified test temperature, containing not less than 10lt. of water, the specimen being immersed to a depth of not less than 100 mm and supported on a perforated shelf not less than 50 mm from the bottom of the bath
Testing Machine : The machine has two rate of travel, namely 5 cms per minute and 1 cm per minute. A clutch arrangement is provided by which the movement of the movable bracket can be arrested or restarted without switching off the motor. A scale on the top edge of the bath makes it easy for the operator to opserve the progress of the test. Machine accommodate three individual specimens. A quick release mechanism permits the operator to move the carriage to any desired position on the track. An automatic cut off prevents over runs. Immersion heater also provided.
A three wire cord with plug is furnished with the bath.
The control panel is recessed. Controls consists of a temperature, an on-offline switch which controls all power to the bath, and pilot light which indicates when the heater are energized. Operation on 230 volts, single phase, 50 cycles, A.C. supply.
Member Since 14 Years
Nature of Business Retailer
For Buyer 
For Seller 
Help 
Rani Jhansi Road, Delhi 
Send Enquiry