Company Information
Member Since 11 Years
Nature of Business ManufacturerAsk for more detail from the seller
Contact Supplier
Electronic Controller can also be used to ON-OFF the Motorised units. This device maintain the lubrication cycle as well as monitors the operation of float Switch and Pressure switch at the same time. Electronic Controllers are suitable for units such as : LAU-03FPS, LAU-05 FPS, LAU-08 FPS & LDU-03 FPS However, cintactor is to be used in this case.
Fault relay contacts can also be used for audio / Visual commands or for interlocking the machine in case of lubrication falure.
In case arrangement for contactor is not possible, ECC-5 can be used. It is a complete solution with in built controller and contactor.
| Power Supply | : | 220V +- 10% AC, 50Hz |
Motor Relay on Time | : | 5 seconds after actuation of pressure switch |
Limitation of motor relay On time | : | 60 seconds in case of pressure failure |
Off Time | : | Selectable 1-128 minutes |
Off Time Setting | : | By Knob |
| Start | : | Motor Relay On when power is turned On. |
| Reset | : | by Pushing the Button Rest. |
Repeat Accuracy | : | +- 10% |
Operating Temperature | : | 0-55°C |
| Maximum Power Consumption | : | 3 VA |
Contact Rating | : | (a) Motor Relay : One potential free NO contact 2 amp non indicative at 220V AC (b) Fault Relay : One potential free change contact 2 amp non indicative at 220V AC |
Lub Shot Facility | : | Alub shot switch parallel to relay contacts provides extra lubrication as and when required. |
Monitoring of Oil Pressure | : | LED Lub fault flickers & fault relay is actuated in case pump fails to develop pressure even in 60 seconds. |
Monitoring of Oil Level | : | LED Low OIL Flickers when oil level in the reservoir goes below the Float Switch. |
Connect with us
For Buyer 
For Seller 
Help 
GT Road, Phagwara, Punjab 
Send Enquiry