Our Product / Services
We offer the best product range of Hydrocyclone.
Hydrocyclone Technical Description Hydrocyclones can be used to separate solids suspended in liquids. In the suspension is prepared in a tank. A stirrer prevents premature settling of the solid particles. An eccentric screw pump delivers the suspension into the tangential inlet of the cyclone. In the cyclone a downward primary vortex is created. The downward taper causes the vortex to reverse. In the middle it moves as a secondary vortex back up towards the immersion tube, where the suspension emerges from the cyclone, having lost the coarse material in it. Inside the cyclone an air core is formed. The centrifugal forces cause the coarser solid particles in the primary vortex to be enriched. They are discharged with the bottom flow at the apex nozzle. It is mainly the fine material that is discharged from the top. The outflow form of the bottom flow changes depending on the solid concentration of the introduced suspension. Where the solid concentration is high, strand discharge occurs. Where the solid concentration is low, the discharge is fan-shaped. The flow rate in the inlet is adjusted by way of the pump speed and measured with a magneto-inductive flow meter. Sampling points are installed at the bottom and top flow points. The flow rates in them can be determined by means of a measuring cup and a stopwatch. To determine the solid concentration, a balance and a drying chamber are recommended. Using a suitable analysis device (such as a diffraction spectrometer), a separation function can be produced and the separation size determined. Quartz powder is recommended for use as the solid.
Rakesh Mittal (Elab Engineering)
F-197/A, ALPHA-2 GREATER NOIDA Gautam Budh Nagar, Uttar Pradesh - 201308, India
Share us via
Write a Review
